1977 el camino fuel sending unit1/19/2024 ![]() This is the Chevy 350 in our toad vehicle, a 1985 Chevy k5 Blazer. Get the Best Performance with JEGS Fuel Tank Sending Unit for 1978-1987 Chevrolet El Camino 78887 parts at JEGS. I really need both the gauges to work! The clock and the volt meter work though.lol! It has a wire going up under the dash for an nonexistant aftermarket gauge. Anyone know where the original water temp sender would have been as well? There is an aftermarket setup in the thermostat housing, but I'm not sure if this was the stock location. The water temp gauge doesn't work either, so I'm a bit puzzled. Reproduction Of Original Requires Top Plate Tab Trimming On Some Model Tanks 3/8 Fuel Line 1/4 Return Line 90 Ohm Sender Your 1973-1977 El Camino fuel sending unit spends its life in a very inhospitable environment and it is prone to fail. ![]() It looks like it could be either a OP sender, or a water temp sender.I guess if I unscrew it I'll find out right quick, but does anyone know if that is the oil pressure sender? The gauge doesn't work and there is no wire going to this sender. ![]() A17 gallon car will not list a code as it is considered standard equipment. A 22 gallon equipped El Camino will be listed with N23 option. There appears to be some sort of a sensor on the side of the engine block on the driver's side, just below the spark plugs and just about in the middle. From the ad: To find out if an El Camino has a 17 or 22 gallon tank, check the option sticker located in the glove box. Anyone know where the oil pressure sender is on a Chevy 350? I looked all over on line, and the concensus was that its next to the distributor, but not on mine!!!
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |